Keep an Eye Out | 3-Ring Flip-Through
Menu
  1. First-Time & Student Skydivers
  2. Experienced Skydivers
  3. Rating Holders and S&TAs
  4. Drop Zone Management
  5. About USPA
Saturday, December 14, 2024
Keep an Eye Out | 3-Ring Flip-Through

Keep an Eye Out | 3-Ring Flip-Through

Keep An Eye Out
Thursday, March 28, 2024

Above: Photo by Erin Orwig.

In the loading area, ground crew noticed that two rings of this jumper’s 3-ring assembly had flipped through the large ring. Although this error—which usually occurs during packing—is more common on larger 3-ring assemblies and on tandem rigs, it can also happen with type-17 risers and their smaller rings.

Jumping a 3-ring system configured this way is extremely hazardous. Not only might it prevent the ability to cut away, it also drastically increases the chance that the riser will release on that side during opening or when under load due to the high forces causing failure of the fabric 3-ring-retainer loop or even the large ring itself.  One manufacturer noted that they had seen a 3-ring system “explode” on opening when configured this way.

A gear check prior to donning the rig would have caught this error. The biggest enemy in this sport is complacency. No one is invulnerable. Check yourself. Check each other. And if you see something, say something.

Print
Categories: Safety & Training, Keep An Eye Out   |   Rate this article:
4.2
  |  Number of views: 11257   |  Comments: 0
Please login or register to post comments.
PARACHUTIST
USPA STORE

USPA      5401 Southpoint Centre Blvd., Fredericksburg, VA, 22407     (540) 604-9740    M-F 9am-5pm Eastern    (540) 604-9741     uspa@uspa.org

Terms Of UsePrivacy StatementCopyright 2024 by United States Parachute Association
Your Source for all things Skydiving in the U.S.
Back To Top